*The store has not been updated recently. You may want to contact the merchant to confirm the availability of the product.
Metal Hardness Tester - HARTIP 3000
To buy, select
(Choose from options to the left)
The HARTIP® 3000 is an advanced hand-held digital metal hardness tester with high accuracy, wide measurement range and easy operation. It is suitable for testing the hardness of all metals and especially used in power, petrochemical, aerospace, and automotive industries.
Large LCD display with back-light
For all metallic materials
Wide measuring range: Rockwell B&C, Brinell, Vickers, Shore and HL
Test in any directions
All impact devices interchangeable
RS 232 interface to PC and micro-printer
Comply to ASTM standard
Accuracy:Main uncertainty +/-4 L value(referred to L=800)
Measuring range: Hardness value L= 200-960
960 groups of data can be stored in individual 8 memory areas
Data acquisition and print out
RS232 interface to PC
Operating temperature: -10°C -- +45°C, impact device: -20°C -+120°C
Power: DC 4x1.5VAA alkaline battery
For D, DL, DC, D+15, and E Impact Devices: a Minimum thickness of 10mm (3/8 inch) is required. The sample weight is required to be over 5kg (11 lbs), however for samples weighing less than (5 kg) 11lbs, you can couple the sample to a solid support weighing over 5kg (11lbs) to achieve accuracy. The maximum roughness of surface finish is 2µ Ra.
For G Impact Device: a Minimum thickness of 10mm is required. The sample weight should be over 15 kg, however for weights less than 15kg, you can use the sample coupling method. The Maximum Roughness should be 7µ Ra.
For C Impact Device: a Minimum thickness of 1mm is required. The sample weight should be over 1.5 kg, however for weights less than 1.5 kg you can couple the sample to a solid support. The Maximum Roughness requirement is 0.5 µ Ra
Impact Device type D
Small support ring
Test block D
Battery: 4 AA
Impact Device: DC, D+15, G, C, E, DL
Test block G
Data management software
Special support rings
Interface cable (to PC or printer)